The E-100-A and E-100-L-A serve as above-insulation end seal kits for Raychem brand BTV, QTVR, XTV, KTV, or VPL heating cables. They are approved by FM and CSA for use in hazardous locations. Both the E-100-A and the E-100-L-A are mounted on the pipe and project through the thermal insulation and cladding for ease of maintenance. The E-100-L-A end seal with signal light uses an array of bright LEDs for exceptional visibility and long product life. These rugged end seals are made from high-performance engineering polymer and resist impact, high temperature, and chemical and UV exposure. The stand allows for up to four inches (100 mm) of thermal insulation. The encapsulated light and boot reliably prevent moisture and dust ingress. The industrial-grade electronics used in the E-100-L-A are encapsulated. Both the E-100-A and E-100-L-A are re-enterable, allowing easy access for testing. Voltage and continuity checks can be done by simply unscrewing the E-100-A cap and removing the reusable sealing boot. The E-100-L-A makes maintenance even easier by allowing for visual inspection of heating circuit continuity. The E-100-L-A can be retrofitted into previously installed E-100-A end seals. The light module is replaceable. The kits contain all the necessary materials for a complete installation except for one pipe strap, which must be ordered separately.

In order to keep connections dry and corrosion resistant, connection kits shall be constructed of nonmetallic, electrostatic, charge-resistant, glass-filled, engineered polymer enclosure rated type 4X(IP66)

Terminals shall be spring clamp wire connection type to provide reliable connection, maintenance free operation and ease of reentry

The connection kit shall be rated to a minimum installation temperature of -40 deg F, minimum usage temperature of -40 deg F and maximum pipe temperature of 500 deg F

277 VAC maximum operating voltage

3 in outer diameter at insulation

Simple and fast to install and test

Resistant to impact high performance, high temperature, chemicals and UV

Reliable during long life

Cold-applied-no heat gun or hot work permit required, re-enterable